Image: Aquajet

Aqua Cutter 410A

AquajetConcrete Construction

Tracked, radio-controlled hydrodemolition robot with a 3 m arm for tunnels, culverts and garages

7
Deployments
7
Companies that ran it

How it works on your site

The Aqua Cutter 410A is a tracked, radio-controlled hydrodemolition robot from Aquajet Systems AB that removes concrete with a high-pressure water jet mounted on a hydraulic articulated arm reaching as far as 3 m. Aquajet specifies it for horizontal, vertical, overhead and curved concrete in tunnels, culverts, parking garages and underwater, and its electric power control module detaches so the submersible crawler works on its own while cord-connected to the module. The 410A is on Aquajet's current range page and runs the older Evolution 2.0 control system.

Concrete Removal and Repair

Field outcomes

1 of 5
  1. Aqua Cutter 410AImage: Aquajet

    Freyssinet USA ran three Aqua Cutter 410A units to strip wall concrete along 4 miles of the Fort McHenry Tunnel in Baltimore.

    Fort McHenry Tunnel conduit replacement and concrete rehabilitation, USA

    Aqua Cutter 410AFreyssinet USA

  2. Aqua Cutter 410AImage: Aquajet

    Corvara was using an Aqua Cutter 410A hydrodemolition robot to remove decayed concrete from ski-lift pylon foundation blocks in Åre, Sweden, under a contract covering 12 blocks from 2015 to the end of 2016.

    Åre cableway ski-lift pylon foundations (12 blocks), Sweden

    Aqua Cutter 410ACorvara

  3. Aqua Cutter 410AImage: Aquajet

    Skanska Norway used Aqua Cutter 410A under the 4,000 square metre pier at Pipervika Quay in Oslo harbour and removed more than 750 tonnes of corroded concrete in 100 days.

    Pipervika Quay pier renovation, Oslo harbour, Norway

    Aqua Cutter 410ASkanska Norway

  4. Aqua Cutter 410AImage: Aquajet

    Azul Construcción used an Aqua Cutter 410A to refurbish expansion and structural joints on six bridges near Seville, including the Santiponce viaducts on the A66, removing 625 cubic meters of damaged concrete, mostly above 40 degrees Celsius.

    Santiponce viaducts (A66), joint refurbishment on 6 bridges, Spain

    Aqua Cutter 410AAzul Construcción

  5. Aqua Cutter 410AImage: Aquajet

    Rampart Hydro-Services used Aqua Cutter 410A and Aqua Cutter 710H to remove concrete along the deck edges of the Pensacola Bay Bridge after Hurricane Sally, working for general contractor Skanska.

    Pensacola Bay Bridge Hurricane Sally repair, USA

    Aqua Cutter 410ARampart Hydro-Services

Will it work on your site

Control interface
Radio remote with interactive graphic displayEvolution 2.0; teach-in by drawing on the surface
Pre-job inputs
Settings calculated from a few operator inputsShapes, speed zones and 3D zones programmed on the remote
Planning app
Aquajet Calculator web appNozzle pressure, flow, reaction force, hose pressure drop

As the maker states it.

Want more information?

We send your request to Aquajet, the maker.

Something wrong? How corrections work

Make this robot? Claim the profile

Leave an email and we'll get in touch about maintaining this profile.